Removing and installing filler neck: VW Jetta VI
Step-by-step removing and installing filler neck for the VW Jetta VI: 5 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Jetta VI (16, 2010–2018)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 4 Nm (3.0 lb-ft) | Tighten bolt |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical consumers, and remove ignition key.
- Pull connecting pipe (3) off filler neck (2) of washer fluid reservoir.
- Remove bolt (1).
- Unclip hose retainer from filler neck (2) and remove from vehicle.
- Tighten threaded connections to specified torque.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Calibrating ACC during vehicle alignment
- Removing and installing rain and light sensor G397, vehicles with front camera for driver assist systems
- Removing and installing rain and light sensor G397, vehicles without front camera for driver assist systems
- Removing and installing steering column combination switch E595, Valeo, interface for entry and start system
- Removing and installing steering column combination switch E595, Kostal, interface for entry and start system
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.