Removing and installing entry and start authorisation control unit J518 — VW

Removing and installing
entry and start authorisation control unit
J518
After renewing the
electronic steering column lock control unit
J518
, the
“entry and start authorisation”
system must be coded
Chapter
.
Removing:
Switch off ignition and all electrical loads, and pull out ignition key.
Remove driver side footwell vent
Heating, ventilation, air conditioning system
Rep. gr.
80
Heating; Repairing heating; Passenger compartment; Removing vents
.
Remove trim in driver's footwell
General body repairs, interior
Rep. gr.
68
Trim; Removing and installing left trim on driver side
.
Remove steering column trim
General body repairs, interior
Rep. gr.
68
.
Note
In order to be able to pull the
entry and start authorisation control unit
J518
together with its holder off the pedal block, the steering column must be lowered.
Caution
Observe the instructions regarding handling and transport of the steering column
Running gear, axles, steering
Rep. gr.
48
Steering column and steering wheel; Handling and transport of steering column
.
Remove both securing bolts
2
.
Unscrew bolt
1
and remove crash strut of clutch pedal
2
.
Unscrew bolt
3
and remove crash strut of brake pedal
4
.
Lower steering column only as far as necessary to allow removal of
entry and start authorisation control unit
J518
from pedal block.
Release catch
arrow
and pull
entry and start authorisation control unit
J518
2
together with holder
3
backwards out of pedal bracket of brake pedal, taking lengths of connected wires into consideration.
Release and detach connector
1
and then remove
entry and start authorisation control unit
J518
2
from holder
3
.
Installing:
Install in the reverse order of removal. When doing this, note the following:
Insert
entry and start authorisation control unit
J518
2
into holder
3
.
Insert bracket together with control unit into guides on pedal bracket of brake pedal until it engages securely.
Re-attach and secure connector
1
.
After renewing the
electronic steering column lock control unit
J518
, the
“entry and start authorisation”
system must be coded
Chapter
.