Removing and installing electronically controlled damping control unit J250, Golf Estate — VW

🧭 Before you start

Fits: platform code BX5

Don't miss

• Function Replace control unit must be performed with if electronically controlled damping control unit J250 has been renewed.
• If the reference position has been re-adapted, the front camera for driver assist systems must be recalibrated on vehicles with lane departure warning function Calibrating front camera for driver assist systems.

📋 Procedure

1. Disconnect battery Electrical system27Battery; Disconnecting and reconnecting battery.
2. Pull out ignition key.
3. Switch off ignition and open driver's door so that the steering lock engages.
4. Remove left side panel trim in luggage compartment General body repairs, interior70Luggage compartment trims; Removing and installing side panel trim for luggage compartment.
5. Remove tool bag.

6. Release lugs (arrows).
7. Remove bracket (1).
8. Unclip control unit (1) from bracket (arrow).
9. Pull out release (1) in (direction of arrow).
10. Pull off connector (2).
11. Push control unit (1) into bracket (2) until lug (arrow) engages in retainer.
12. Function Replace control unit must be performed with if electronically controlled damping control unit J250 has been renewed.
13. If the reference position has been re-adapted, the front camera for driver assist systems must be recalibrated on vehicles with lane departure warning function Calibrating front camera for driver assist systems.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures