Removing and installing cross piece — VW

🧭 Before you start

Fits: platform codes 5C7, 5C1

Don't miss

• Lug (arrow A) of strut (1) must point towards lug (arrow B) of subframe (2).
• Flap (1) must be heard to engage in lower part (arrow A).

📋 Procedure

1. Raise vehicle.
2. Remove plug from longitudinal member and pull in tensioning strap T10038.
3. Remove coil springs .
4. Release flap (1)(arrow A) and open.
5. Position engine and gearbox jackV.A.G 1383 A under axle beam.

6. Press axle beam upwards until cross piece (2) is horizontal.
7. Undo and remove bolted joint (1).
8. Unscrew bolted joint (1) and remove cross piece (2).
9. Lug (arrow A) of strut (1) must point towards lug (arrow B) of subframe (2).
10. Flap (1) must be heard to engage in lower part (arrow A).
11. Install coil spring .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Renewing side light bulb
• Converting headlights for use when driving on the left or right
• Dismantling and assembling input shaft from gearbox date 13 01 3
• Repair of connectors terminals
• Handbrake (disc brake) - adjust