Removing and installing control unit for auxiliary hydraulic pump J922 — VW

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

Don't miss

• Connector is automatically ejected on folding bow up, and electrical connection is separated.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off ignition and all electrical consumers, and remove ignition key.
2. Removing front right wheel housing liner General body repairs, exterior66Wheel housing liners.
3. Open cap (1), pull black primary lock of bow and fold bow upwards. [Note: Connector is automatically ejected on folding bow up, and electrical connection is separated.]
4. Release and disconnect both connectors (2) and (3).
5. Unscrew both bolts (arrows) and remove control unit for auxiliary hydraulic pump J922(1) together with bracket out of wheel housing.
6. Tighten both securing bolts for bracket to body to 9 Nm. — 9 Nm (6.6 lb-ft)

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing camshaft timing chain and intermediate shaft drive chain · 4 torque figures
• Removing and installing treble horn H2 and bass horn H7 · 9 torque figures
• Removing and installing left temperature flap control motor V158 · 8 torque figures
• Installing bevel box – VW Golf V / Jetta · 7 torque figures
• Removing and installing fuel tank 1 and 2 – VW 1.4 CDGA · 4 torque figures