Removing and installing centre console without armrest — VW

🧭 Before you start

Fits: platform code 137

Don't miss

• An ashtray may be installed instead of a storage compartment (3), but the removal is identical.
• Removal of right footwell trim is identical.
• When installing, bolts must be installed in sequence (2), (3), (6), (4) and (5).

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off ignition.
2. Release gearstick boot or gear shift cover respectively from mountings 34.
3. Remove hand brake lever trim Brake system46Assembly overview - hand brake lever
4. Remove lining mats (1) and (3).
5. Unscrew bolt (2) (1.5 Nm). — 1.5 Nm (1.1 lb-ft)

6. Remove the two bolts (4) (1.5 Nm). — 1.5 Nm (1.1 lb-ft)
7. Detach extension from mountings and separate wiring harness from "„AUX in“" socket if fitted.
8. Thread extension (5) through handbrake handle aperture.
9. Release selector insulation (1) from centre console.
10. Remove the two bolts (2) (1.5 Nm). — 1.5 Nm (1.1 lb-ft)
11. Release storage compartments (3) from centre console and disconnect wiring harness (dependent on vehicle equipment). [Note: An ashtray may be installed instead of a storage compartment (3), but the removal is identical.]
12. Unclip cover (1) from trim using a small screwdriver.
13. Unscrew bolt (2) (1.5 Nm). — 1.5 Nm (1.1 lb-ft)
14. Pull left footwell trim (3) out of mountings. [Note: Removal of right footwell trim is identical.]
15. Unclip both side trims (4) from centre console by releasing fasteners with a removal wedge3409.
16. Remove lining mat (1) from drinks holder.
17. Remove two bolts (2) and (3) (1.5 Nm) respectively. — 1.5 Nm (1.1 lb-ft)
18. Remove two bolts (4) and (5) (1.5 Nm) respectively. — 1.5 Nm (1.1 lb-ft)
19. Unscrew bolt (6) (1.5 Nm). [Note: When installing, bolts must be installed in sequence (2), (3), (6), (4) and (5).] — 1.5 Nm (1.1 lb-ft)
20. Raise centre console in rear area.
21. Remove centre console from vehicle.
22. Install in reverse order of removal.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing fuel tanks together with mounting, natural gas tanks made of steel
• Removing and installing fuel tanks together with mounting, natural gas tanks made of composite material
• Removing and installing camshaft, version A – VW
• Removing and installing camshaft, version B – VW
• Removing and installing mechatronic unit – VW Jetta VI