Removing and installing brake caliper, front brakes C60: VW Sharan II / SEAT Alhambra
Step-by-step removing and installing brake caliper, front brakes C60 for the VW Sharan II / SEAT Alhambra: 16 steps.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)
- Opens: brake fluid
Don't miss
- Unscrew both securing bolts from brake caliper; to do this, counterhold on guide pin.
- Firmly depress brake pedal several times with vehicle stationary so that the brake pads are properly seated in their normal operating position.Check brake fluid level.
📋 Procedure
- Remove front wheel on relevant side.
- Disconnect connector for brake pad wear indicator.
- Connect bleeder hose of bleeder bottle (1) to bleeder valve of brake caliper.
- Open bleeder valve.
- Apply brake pedal depressorV.A.G 1869/2.
- Close bleed valve and remove bleed bottle.
- Unscrew brake hose.
- Unscrew both securing bolts from brake caliper; to do this, counterhold on guide pin.
- Pull brake caliper off brake carrier.
- Carefully place the brake caliper on the brake support plate.
- Secure brake caliper to brake support plate with new self-locking bolts, counterholding with the guide bolts.
- Screw brake hose onto brake caliper.
- Remove brake pedal depressorV.A.G 1869/2.
- Connect brake pad wear indicator connector.
- Bleed brake system .
- Fit wheel. [Note: Firmly depress brake pedal several times with vehicle stationary so that the brake pads are properly seated in their normal operating position.Check brake fluid level.]
🎬 Related video tutorial
Independent AUTODOC tutorial for the same job, filmed on a different model (T5 TRANSPORTER Van) — the technique carries over, the fasteners and figures on this page are the ones for your car.
How to change front brake caliper on VW T5 TRANSPORTER Van
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing oil spray jets – VW Jetta VI
- Removing and installing lock carrier trim – VW Touran II
- Checking current draw of fuel pump, engine codes CBAA, CBAB, CBBB, CBAC
- Removing and installing washer fluid reservoir, one-piece version
- Removing and installing tail light MX3/MX4, Saloon
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.