TorqFix

Removing and installing bracket: VW Polo 9N

Step-by-step removing and installing bracket for the VW Polo 9N: 14 steps. What to remove, in what order, and what to check after.

Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.

14 steps

🧭 Before you start

Fits: VW Polo 9N (2001–2009)

📋 Procedure

  1. Removing suspension link
  2. Remove hexagon nut (1) from coupling rod (left and right sides).
  3. Pull out coupling rod (3) from anti-roll bar (2) on left and right side.
  4. Remove bolts (arrows).
  5. Remove bolts (arrows).
VW? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Fix position of subframe .
  2. Remove bracket (1) from subframe.
  3. Fit bracket in subframe.
  4. Fit and tighten bolts (arrows).
  5. Secure subframe .
  6. Bolt anti-roll bar to bracket (arrows).
  7. Fit coupling rod (3) in anti-roll bar (2) on left and right side.
  8. Tighten hexagon nut (1) on left and right side.
  9. Install suspension link .

Other VW procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.