Removing and installing bonnet lock, LHD vehicle: VW Passat B8

🧭 Before you start

Fits: VW Passat B8 (3G, 2014–)

Don't miss

• The connector is secured next to the right headlight.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Open bonnet.
2. Remove Bowden cable on mounting bracket .
3. Disconnect connector for bonnet contact switch (5). [Note: The connector is secured next to the right headlight.]
4. Lift caps (4) off bolts.
5. Remove bolts (3) from lock carrier and remove bonnet lock (1) upwards (arrow a).

6. Unclip retainer (7) from bonnet lock.
7. Slightly remove retainer (7) from bonnet lock (1)(arrow b) and unhook cable (6)(arrow c).
8. Remove microswitch (5) from bonnet lock.
9. Hook in cable (4)(arrow a) and clip retainer (3) into bonnet lock (1)(arrow b).
10. Install microswitch (6) in bonnet lock.
11. Insert bonnet lock (1) into lock carrier (arrow c).
12. Screw in new bolts (3).
13. Connect connector for bonnet contact switch (6).
14. Install Bowden cable on mounting bracket .
15. Adjust bonnet lock .
16. Install caps (4).
17. Before closing bonnet, check function of release lever and cable.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures