Removing and installing battery tray — VW
Removing and installing battery tray on VW: 8 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 601, 602, 612, 641, 642, 643, 604, 644, 614, 603
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 15 Nm (11 lb-ft) | Tighten threaded connections to specified torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove battery .
- Pull off connected cable retainer (1) on back of battery tray.
- Remove both securing nuts and the securing bolt (arrows).
- Pull off rubber drainage hose on back of battery tray.
- Remove battery tray from vehicle.
- Tighten threaded connections to specified torque: 15 Nm. — 15 Nm (11 lb-ft)
- Install battery .
- Connect battery .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Assembly order, gearbox »without« retaining ring (A) for input shaft sealing cover
- Assembly order, gearbox »with« retaining ring (A) for input shaft sealing cover
- Assembly overview - Removing and installing Haldex coupling cover with plate housing, set of plates, pinion housing with shaft bevel gear, bevel gear with stub shaft and differential
- Removing and installing emission control module, version 1
- Dismantling and assembling gearbox
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.