Removing and installing alternator, vehicles with 1.6 l MPI engine — VW
Removing and installing alternator, vehicles with 1.6 l MPI engine on VW: 14 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes AU1, BX5
Don't miss
- Always start engine and check belt running after completing work.
📋 Procedure
- Disconnect batteryA.
- Remove poly V-belt 13Cylinder block on pulley side; Removing and installing poly V-belt.
- Remove tensioner for poly V-belt 13Cylinder block (pulley end); Removing and installing tensioner for poly V-belt.
- ⚠ Risk of damage to air conditioner compressor, refrigerant lines and refrigerant hoses:Make sure refrigerant lines and hoses are not excessively stretched, kinked or bent. — Remove air conditioner compressor from bracket Heating, air conditioning system87Air conditioner compressor; Removing air conditioner compressor from and installing on bracket.
- Secure air conditioner compressor to lock carrier so that refrigerant lines are not under tension.
- Remove bolts (arrows).
- Remove alternatorC(1) from bracket with electrical wiring still connected.
- Release connector (3) and disconnect.
- Pry off cap (2).
- Unscrew nut and remove terminal 30/B+ (4).
- Remove alternatorC(1) downwards to the right.
- To facilitate positioning of alternatorC, slide bushes of alternator mounting slightly towards back.
- Reconnect batteryA.
- Always start engine and check belt running after completing work.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing rear axle, four-wheel drive · 1 torque figures
- Removing and installing petrol fuel tank – VW 1.4 CDGA/CPGA · 1 torque figures
- Removing and installing Denso belt pulley · 3 torque figures
- Adjusting selector lever cable · 4 torque figures
- Checking valve timing, vehicles with adjustable exhaust camshaft · 2 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.