Removing and installing aerial module R108/R109 — VW
Removing and installing aerial module R108/R109 on VW: 6 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code A32
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Unscrew securing bolt (arrow |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical loads, and pull out ignition key.
- Remove C-pillar trim General body repairs, interior70Trims, interior; Removing and installing C-pillar trim.
- Release and disconnect connectors (arrows) from aerial module.
- Unscrew securing bolt (arrow) (2 Nm). — 2 Nm (1.5 lb-ft)
- Push aerial module in (direction of arrow).
- Remove aerial module from body.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- 4-speed automatic gearbox 099, four-wheel drive — Removing and installing oil seals for front right flange shaft and front right bevel gear with stub shaft
- Removing gearbox; Passat 2006 ► 1.4 l - 110 kW - Eco-Fuel engine
- Removing and installing vane pump, W12 petrol engine – VW
- Removing and installing driver/front passenger curtain airbag, 4-door, (Golf 2009 ►) · 2 torque figures
- Removing and installing curtain airbag, Passat CC 2009► and CC 2010► · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.