Removing and installing AC/DC converter with socket, 12 V - 230 VU13 — VW

🧭 Before you start

Fits: VW Passat B8 (3G, 2014–)

📋 Procedure

1. ⚠ There is a danger of an electric shock.In the housing of the DC/AC converter with socket, 12 V - 230 VU13 there are capacitors that may still be charged with a residual voltage.Never open the housing of the DC/AC converter with socket, 12 V - 230 VU13.The connector, wiring and 230 V socket must never be repaired.The complete unit must be replaced if the connector, wiring and 230 V socket or the AC/DC converter are defective. — Switch off ignition.
2. Store ignition key in a place outside the vehicle to prevent the ignition from being switched on unintentionally.
3. Unclip trim for electric socket from rear centre console trim.
4. Press fasteners (1) in direction of arrows (A) and (B), respectively.
5. Pull socket (2) out of trim.

6. Remove centre console General body repairs, interior68Centre console; Removing and installing centre console.
7. Release and disconnect connector for 12 V power supply.
8. Move clear wires (2) and (3).
9. Remove bolts (4).
10. Remove DC/AC converter with socket, 12 V - 230 VU13(1) with bracket in (direction of arrow) from centre console.
11. Remove bolts (3).
12. Remove DC/AC converter with socket, 12 V - 230 VU13(1) from bracket (2).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures