Rear window drive mechanism - remove and install — VW

🧭 Before you start

Fits: platform codes 6A1, 6A5

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove rear door lining General body repairs, interior70 Lining / insulation.
2. Remove the door window glass .
3. Remove rear window drive .
4. Unlock the retaining hooks of the drum for cable (arrows a) and push on the door.
5. Release the hexagonal nuts (2) and push the threaded pins of the door window mechanism (arrows b).

6. Rotate the door window mechanism, a little, in the (direction of arrow c).
7. Remove the window mechanism (1) through the door opening (arrow d).
8. Introduce the window mechanism (1) through the door opening (arrow a) and bring it to the installation position (arrow b).
9. Fit the threaded pins of the window mechanism through the door internal panel (arrows c).
10. Fasten the hexagonal nuts (2), torque: 8 Nm. — 8 Nm (5.9 lb-ft)
11. Press the drum for cable against the door inner section (arrows d), until the retaining hooks clock into place.
12. Install rear window drive .
13. Install the door window .
14. Install the rear door trim Body - Internal assembly jobs70Trims/insulations.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures