Rear door lock - remove and install — VW

🧭 Before you start

Fits: platform codes 6A1, 6A5

Don't miss

• As long as required for the next jobs, the cables can be released.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove the window winder .
2. Remove rear door lining General body repairs, interior70 Lining / insulation.
3. Remove the cover .
4. Remove the protective cap
5. When existent, disconnect the connectors.

6. Remove the screws (4).
7. Remove door lock (1)(arrow f). [Note: As long as required for the next jobs, the cables can be released.]
8. Rotate cable (3) 90° and remove it from support (arrow a).
9. Rotate cable (arrow b) until the cable can be removed through the door lock eye (1)(arrow c).
10. Rotate cable (2) 90° and remove it from support.
11. Rotate cable (arrow d) until the cable can be removed through the door lock eye (1)(arrow e).
12. Install the removed cables (2) and (3) on door lock (1).
13. Insert lock (1) into door (arrow f).
14. When existent, connect the connectors.
15. Fasten bolts (4).
16. Fit the protective cap (5).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures