Radiator fan V7 - remove and install — VW

🧭 Before you start

Fits: platform codes 6A1, 6A5

• Opens: coolant

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. ⚠ When opened, hot vapours may come from the coolant tank. Wear protection goggles and clothing to prevent eye injuries and burns. Place a cloth on the cap and open it carefully. — Drain cooling system .
2. Remove bumper cover General body repairs, exterior63Bumpers.
3. Remove the radiator .
4. Remove the Radiator fan V7 air deflector.
5. Remove the bolt (1) from the air deflector (2).

6. Press the lock in the direction of the (arrow) and remove the connector (3).
7. Loosen the bolts (arrows).
8. Remove the electric harness (3) from the air deflector (2).
9. Remove the Radiator fan V7(2) from the air deflector (1).
10. Replenish cooling system .
11. Install bumper cover General body repairs, exterior63Bumpers.

Other VW procedures

• Camshaft mechanism - repair
• Crankshaft flange with Engine speed sensor G28 rotor (flywheel side) - remove
• Fuel pump (pre-supply pump)G6 check valve - examine
• Cylinder head - assembly and disassembly
• Lubricating system components - assembly overview
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures