Installing rear shelf — VW
Installing rear shelf on VW: 10 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 1F7
Don't miss
- Tensioning element, EosVAS 6373 and pretensioning tool, EosVAS 6389 are used to tension the mounting frame and the latch bearing.
- The stop buffer must be open to do this.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 22 Nm (16 lb-ft) | Tighten rear shelf bolts, specified torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Restore rear lid service position.
- Push rear shelf (1) in between rear lid (2) and assembly frame (3) with the help of a second mechanic.
- Install bolts (4).
- Set noted dimension between rear stop buffers on assembly frame (3).
- Ensure that shut lines all around are an even 4 mm (arrows) and tighten bolts to applied marks. [Note: Tensioning element, EosVAS 6373 and pretensioning tool, EosVAS 6389 are used to tension the mounting frame and the latch bearing.]
- Insert pretensioning tool, EosVAS 6389/2 between mounting frame and latch bearing.
- Tighten pretensioning tool, EosVAS 6389/1.
- Guide tensioning element, EosVAS 6373 into aperture to stop. Turn tensioning element 90°.
- The stop buffer must be open to do this.
- Tighten rear shelf bolts, specified torque: 22 Nm. — 22 Nm (16 lb-ft)
Other VW procedures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.