Installing propshaft tubes: VW Sharan I / SEAT Alhambra
Step-by-step installing propshaft tubes for the VW Sharan I / SEAT Alhambra: 4 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan I / SEAT Alhambra (7M)
Don't miss
- After installing propshaft, tighten intermediate bearing bolts to body to 20 Nm torque.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 20 Nm (15 lb-ft) | After installing propshaft, tighten intermediate bearing bolts to body |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- When bolting propshaft tubes together, line up spots of paint, dot to dot.
- If flanges of propshaft tubes are to be removed, first transfer spots of paint to flanges.
- Align intermediate bearing in its elongated holes so that propshaft is not under tension.
- After installing propshaft, tighten intermediate bearing bolts to body to 20 Nm torque. — 20 Nm (15 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing gearbox, Golf 2004 ►, with 3.2 l V6 engine (all-wheel drive)
- Removing and installing gearbox, Golf 2009 ► vehicles with all-wheel drive
- Removing gearbox - vehicles with 2.0 l - 125/132/147 kW TSFI engine
- Removing engine, Golf, Golf Plus, Golf Cabriolet, Polo
- Removing and installing cylinder head, Polo, Golf, Golf Plus, Golf Cabrio, Touran
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.