Installing exterior seal: VW Sharan II / SEAT Alhambra

🧭 Before you start

Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)

Don't miss

• Entire bonding surface on roof cut-out must be free of dust and grease.
• The seal must not pull into the radii, otherwise the seal will stretch and compress.

📋 Procedure

1. Entire bonding surface on roof cut-out must be free of dust and grease.
2. Clean complete bonding area with cleaning solution.
3. Prime bonding areas on roof cut-out using plastic primerD 366 PR1 A1.
4. Observe flash-off time of 10 minutes.
5. Centre new exterior seal (1) with joint (arrow) to centre of rear roof cut-out.

6. Pull protective film from adhesive tape (3) of new exterior seal (1) and press seal onto roof (3).
7. The seal must not pull into the radii, otherwise the seal will stretch and compress.
8. Press exterior seal on firmly and evenly 2x around circumference using roller3356.
9. Install rear glass panel .
10. Install front glass panel .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing centre armrest – VW Golf Sportsvan · 3 torque figures
• Removing and installing trim on sill side – VW Touareg II · 2 torque figures
• Removing and installing tail light (tail light cluster) with light diodes in side panel · 2 torque figures
• Removing and installing parking aid control unit J446, left-hand drive vehicle · 3 torque figures
• Measuring radial play of camshaft – VW Touareg II · 3 torque figures