Generator (Alternator)C for 1.0 and 1.6l (ARA, BPA, BAH) engines - remove and install — VW

🧭 Before you start

Fits: platform codes 9A2, 9A4, 9A5, 9A1, 9A3, 9A6

Don't miss

• Mark the Poly-V belt movement direction.
• After installation, start the engine and check the belt motion.

📋 Procedure

1. Turn off the ignition, all the electrical devices, and remove the key from ignition.
2. Disconnect the BatteryA.
3. Remove the engine cover Engine24Supply system - fuel injection.
4. Remove the lower engine noise insulation, if necessary General body repairs, exterior50Body - Front section.
5. Disengage connector (1) and remove protective cover (2).

6. Loosen fastening nut (arrow) on cable (B+) and remove the cable.
7. Loosen fastening nut (arrow) from the Generator (Alternator)Ccable support.
8. Mark the Poly-V belt movement direction.
9. Remove Poly-V belt Engine13Crankshaft, pistons.
10. Loosen the fastening screws (arrows) from the Generator (Alternator)C.
11. Remove the Generator (Alternator)C.
12. First, place Poly-V belt on the crankshaft pulley, and then on the tensioning roller, as indicated on the belt run Engine13Crankshaft, pistons.
13. Tighten the fastening nuts and screws to the specified tightening torque . [Note: After installation, start the engine and check the belt motion.]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Installing Bowden cables for sunroof blind · 1 torque figures
• Removing roof side member flap
• Adjusting door window to front window channel · 1 torque figures
• Removing and installing ancillary bracket for air conditioner compressor, engine codes BUB, CBRA and CDVA · 1 torque figures
• Removing and installing steering wheel operating unit · 1 torque figures