Gearbox oil - check and refill — VW

🧭 Before you start

Fits: platform codes 6A1, 6A5

Don't miss

• The oil level will be OK if the gearbox has oil up to the lower edge of the checking hole.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Loosen screw (plug) (arrow) to check oil level. [Note: The oil level will be OK if the gearbox has oil up to the lower edge of the checking hole.]
2. Install the screw (plug) (arrow) with a torque of 32 Nm. — 32 Nm (24 lb-ft)
3. Loosen screw (plug) (arrow).
4. Fill with the specified oil up to the lower edge of the checking hole.
5. Install screw (plug) (seta).
6. Start engine, engage a gear and let the gearbox functioning by approx. 2 minutes.
7. Stop engine and replenish with oil up to the lower edge of the checking hole.
8. Install the screw (plug) (arrow) with a torque of 32 Nm. — 32 Nm (24 lb-ft)

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing alternator, 1.4 l 55 kW injection engine
• Removing and installing engine control unit - Jetta from MY 2011
• Installing gearbox, vehicles with 2.5 l - 110 kW and 2.5 l - 125 kW engines
• Removing and installing airbag unit on driver side (Jetta 2010 ►, Golf estate 2010 ►)
• Removing and installing telephone bracket R126 ▸ 06/2006 · 1 torque figures