Front seat belt lower fastening point (Gol/Voyage) - remove and install — VW

🧭 Before you start

Fits: platform codes 5U8, 5U9, 5U2, 5U1

Don't miss

• The shape of the lower attachment point of the belt prevents it from being assembled incorrectly.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove the B-pillar lower lining .
2. Remove the securing bolt (1).
3. Remove the lower fastening point of seat belt (2). [Note: The shape of the lower attachment point of the belt prevents it from being assembled incorrectly.]
4. Install the lower fastening point of seat belt (2).
5. Tighten the securing bolt (1) to the torque of (40 Nm). — 40 Nm (30 lb-ft)
6. Install B-pillar lower lining .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures