Four-wheel drive - renewing seal between gearbox and bevel box with gearbox installed — VW

🧭 Before you start

Fits: VW Sharan II / SEAT Alhambra (7N, 2010–), VW Tiguan I (5N, 2007–2016)

📋 Procedure

1. Remove bevel box .
2. Remove bevel box .
3. Remove bevel box .
4. Remove bevel box .
5. Remove bevel box .

6. Place drip tray under gearbox.
7. Lever bevel box oil seal out of clutch housing.
8. Lightly oil outer circumference of oil seal and half-fill space between sealing lips (arrow) with grease.
9. Drive bevel box oil seal into clutch housing to stop, being careful not to cant oil seal.
10. Install bevel box .
11. Install bevel box .
12. Install bevel box .
13. Install bevel box .
14. Install bevel box .
15. Check gear oil in gearbox .
16. Check gear oil in bevel box .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing tank for reducing agent, Tiguan
• Removing and installing oil filter element – VW Polo 6R 1.2 · 1 torque figures
• Removing and installing fuel tank (CFWA) – VW Polo 6R 1.2 TDI
• Removing and installing the fuel delivery unit/fuel gauge sender (CAYA, CAYB, CAYC)
• Removing and installing alternator, vehicles with 1.4 l/110 kW TSI engine