Draining and filling oil for Haldex coupling: VW Golf V / Jetta / Passat B6
Step-by-step draining and filling oil for Haldex coupling for the VW Golf V / Jetta / Passat B6: 10 steps, 2 torque figures.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Golf V / Jetta (1K, 2003–2009), VW Passat B6 (3C, 2005–2010)
Don't miss
- Risk of injuryWear acid-resistant gloves — Position used oil collection and extraction unitV.A.G 1782 under final drive.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 15 Nm (11 lb-ft) | Screw in plug (arrow) and tighten |
| 30 Nm (22 lb-ft) | Install drain plug (A) with new seal and tighten |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Cover cross member with cloth.
- ⚠ Risk of injuryWear acid-resistant gloves — Position used oil collection and extraction unitV.A.G 1782 under final drive.
- Remove drain plug (A) and drain high-performance oil for Haldex coupling completely.
- Install drain plug (A) with new seal and tighten to 30 Nm. — 30 Nm (22 lb-ft)
- Unscrew oil filler plug (B). (For sake of clarity, shown with final drive removed.)
- Screw adapter6291/1-2(A) in to stop.
- Engage elbow (B) in adapter (A).
- Using filling deviceVAS 6262 A, add enough oil so that it runs out between the adapter of the filling device and the final drive housing.
- Remove filling device and adapter; excess oil may still run out.
- Screw in plug (arrow) and tighten. Tightening torque: 15 Nm. — 15 Nm (11 lb-ft)
Other VW procedures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.