Coding convenience system control unit using fault reader V.A.G 1551 — VW

Notes:

When supplied the control unit is precoded according to the vehicle equipment.
The coding is performed with the fault reader V.A.G 1551=>Page
01-179
.

Connecting fault reader => Page
01-170
.

Rapid data transfer
HELP
Select function XX
Indicated on display:

Press keys -0- and -7- (with 07 the function "Code control unit" is selected).

Rapid data transfer
Q
07 Code control unit
Indicated on display:

Confirm entry with the Q key.

Code control unit
Q
Enter code number
XXXXX (0-32000)
Indicated on display:

- Enter code number according to table:

Coding table

Vehicle equipment · Code number
Central locking · 1 door opening · 00256
2- Elect. windows · All door opening · 00257
Central locking · 1 door opening · 00258
2- Elect. windows and memory · All door opening · 00259
Central locking · 1 door opening · 04096
4- Elect. windows · All door opening · 04097
Central locking · 1 door opening · 04098
4- Elect. windows and memory · All door opening · 04099

Confirm entry with the Q key.

1J0959799J 03
Conv. cent. CU
0001⇒
Coding XXXXX
WSC XXXXX
The control unit identification number will be displayed with the appropriate index letter, the code number and the workshop code.

If the contents of the display are as shown then the coding is successful.

If the code number entered is not accepted by the control unit, the previous coding will appear in the display:

1J0959799J 03
Conv. cent. CU
0001⇒
Coding XXXXX
WSC XXXXX
Indicated on display:

In this case the control unit has not been programmed with the relevant data for the vehicle.
A check must then be completed to see if the correct control unit for the vehicle has been installed (compare Part No. and letter index), or whether an incorrect code number has been entered.

Repeat coding.

If the control unit cannot be coded (correct control unit, correct code number), the control unit is defective.

Furthermore, at this point the door control unit is called-up and checked.

Ending function:

Press ⇒key.

Rapid data transfer
HELP
Select function XX
Indicated on display:

Press keys -0- and -6- to end the output.

Rapid data transfer
Q
06 End output
Indicated on display:

Confirm entry with the Q key.

Rapid data transfer
HELP
Enter address word XX
Indicated on display:

Switch off ignition.
Disconnect connector to fault reader V.A.G 1551.