Checking oil in front final drive: VW Passat B5

🧭 Before you start

Fits: VW Passat B5 (3B)

📋 Procedure

1. Drive vehicle a short distance to warm up gear oil.
2. Position vehicle over pit or on 4-pillar hoist so that it stands level.
3. Switch off engine and allow oil to settle for approx. 5 minutes.
4. Remove right drive shaft noise insulation from wheel housing (arrows).
5. Place drip trayV.A.G 1306 underneath.

6. Remove oil plug.
7. Allow excess gear oil to pour out or top up as necessary.
8. If gear oil needs to be replenished following repair work, fill front final drive slowly and evenly over a period of at least 5 minutes until gear oil drips out over lower edge of oil filler hole.
9. Screw in old plug.
10. Drive vehicle a short distance to warm up gear oil.
11. Check oil level in final drive again.
12. When oil level is correct, renew oil plug for front final drive .
13. Fit noise insulation for drive shaft at the right wheel housing.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing over-centre spring, Golf Sportsvan, Passat, Touran
• Removing and installing rain and light sensor G397, vehicles with humidity sender G355 and without front camera for driver assist systems
• Removing and installing high-voltage wiring harness for high-voltage batteryPX1
• Removing and installing alternator, vehicles with 1.8 l TSI engine and 2.0 l TSI engine
• Removing and installing high-pressure turbocharger – VW CUAA