Checking lines to fuel tank and fuel cap — VW
Checking lines to fuel tank and fuel cap on VW: 10 steps, engines ADX, AEA, AEE, AER. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 6N1
- Renewed: fuel tank cap
Don't miss
- Operate hand-operated vacuum pumpV.A.G 1390 several times. Vacuum must not build up.
- If fuel level in tank is low the hand vacuum must be operated at least 20...30 times.
📐 9 workshop diagrams for ADX
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Pull vent hose (1) from fuel tank off activated charcoal filter (2).
- Then connect hand vacuum pumpV.A.G 1390 and vacuum testerV.A.G 1368 as shown to hose (1).
- Set vacuum tester to -A/B- position.
- Remove fuel filler cap.
- Operate hand-operated vacuum pumpV.A.G 1390 several times. Vacuum must not build up.
- Check gravity/overflow valve .
- Check line (1) from fuel tank for free-flow.
- Refit fuel filler cap.
- Operate hand-operated vacuum pumpV.A.G 1390 several times. Vacuum must not build up. [Note: If fuel level in tank is low the hand vacuum must be operated at least 20...30 times.]
- Renew fuel tank cap.
Ask TorqFix about your VW ADX — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your VW ADX — free → or sign up free to see the drawingsOther VW procedures
- Checking function and voltage supply – VW Polo 6R
- Vehicles with chain driven oil pump
- VW Notes on removing gearbox removal & installation · 10 torque figures
- VW Notes on installing gearbox removal & installation · 6 torque figures
- VW Procedure gearbox removal & installation · 4 torque figures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.