Checking:: VW Sharan II / SEAT Alhambra
Step-by-step checking: for the VW Sharan II / SEAT Alhambra: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)
- Opens: fuel
Don't miss
- If the ambient temperature is above 20 °C, fuel vaporisation may lead to incorrect measurements.No bubbles are to be delivered.
📋 Procedure
- ⚠ Danger of fuel escaping.Fuel system is under pressure.Before opening system, wrap a cloth around the connection. Then release pressure by carefully loosening the connection. — Disconnect fuel line at metering pump V54 and seal using suitable means.
- Connect approx. 300 mm of fuel line to metering pump V54.
- Hold measuring glass at same height as auxiliary heater.
- Using vehicle diagnosis, testing and information systemVAS 5051B, open guided function "„Check quantity of fuel delivered“" (open fuel line for metering pump V54) and start.
- Seal fuel line.
- Empty measuring glass.
- Hold measuring glass at same height as auxiliary heater.
- Using vehicle diagnosis, testing and information systemVAS 5051B, open guided function "„Check quantity of fuel delivered“" (open fuel line for metering pump V54) and start.
- Connect connector to fuel line.
- Read measuring glass. Fuel delivery rate for petrol and diesel: 22 to 28 ml
- If fuel delivery rate is not within specifications, renew metering pump V54. [Note: If the ambient temperature is above 20 °C, fuel vaporisation may lead to incorrect measurements.No bubbles are to be delivered.]
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing brake caliper, brake caliper FN 44
- Removing and installing air compressor V534 and pressure accumulator
- Removing and installing expansion valve with refrigerant circulation solenoid valve N43
- Assembly overview - rear wheel suspension, four-wheel drive
- Removing and installing axle beam, four-wheel drive
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.