Check oil level in manual gearbox and top up — VW
Check oil level in manual gearbox and top up on VW: 8 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan II / SEAT Alhambra (7N, 2010–), VW Tiguan I (5N, 2007–2016)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 45 Nm (33 lb-ft) | Install bolt (arrow) with new seal and tighten |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove noise insulation General body repairs, exterior50Noise insulation.
- To check gear oil, remove oil plug (arrow).
- Install bolt (arrow) with new seal and tighten to 45 Nm. — 45 Nm (33 lb-ft)
- Remove oil plug (arrow).
- Fill with gear oil to lower edge of filler hole.
- Install bolt (arrow) with new seal and tighten to 45 Nm. — 45 Nm (33 lb-ft)
- If present, attach noise insulation to gearbox.
- Install noise insulation below engine and gearbox.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Front protector - remove and install · 5 torque figures
- VW 1.2 TDI ANY/AYZ gearbox removal & installation
- ANY / AYZ
- Golf4/Bora/Beetle 1.9 TDi (AGR,AHF,ALH,ASV)
- VW Golf4, Bora 1.9 SDi AGP/AQM timing belt replacement
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.