Brake light switch to week 45 of 2006 — VW
Brake light switch to week 45 of 2006 on VW: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan I / SEAT Alhambra (7M)
Don't miss
- Before installing, pull plunger out fully.
📋 Procedure
- Remove trim on driver's side General body repairs, interior70Dash panel
- If necessary, remove footwell vent Heater, air conditioning system80Repairing heater; Removing vent.
- Pull connector off brake light switch.
- Remove brake light switch by turning 90° or 45° to left.
- Before installing, pull plunger out fully.
- Push brake pedal down as far as possible by hand.
- Guide brake light switch through fitting hole and reinstall by turning 90° to right.
- Release brake pedal.
- Fit brake light switch connector.
- Check function of brake light.
- After adjusting the brake light switch check whether the brake pedal is on the end stop (rest position).
Other VW procedures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.