Automatic gearbox 001 — Removing and installing valve body — VW

🧭 Before you start

Fits: VW Polo 9N (2001–2009)

• Renewed: seal, seal to plug, o-rings

Don't miss

• Do not run engine or tow vehicle with pan removed or when there is no ATF in gearbox. — Finally, check ATF level and top up .
• Cut open seal (arrow) with side-cutting pliers; always renew seal.
• Do not interchange (A) and (B) and install in the same places.

📋 Procedure

1. ⚠ Do not run engine or tow vehicle with pan removed or when there is no ATF in gearbox. — Finally, check ATF level and top up .
2. Cut open seal (arrow) with side-cutting pliers; always renew seal.
3. After repairs, fit new seal to plug and screw in hand-tight when filling with ATF.
4. Fill with ATF; check ATF level and top up .
5. Remove bolt (1) and remove wire from valve.

6. Remove bolts (arrows).
7. Separate connector (2).
8. Remove solenoid valve N93.
9. Renew O-rings.
10. Remove solenoid valve N93.
11. Do not interchange (A) and (B) and install in the same places.
12. Attach brackets (1) and (2) and metal tab (3) as shown.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures