Adjusting rear glass panel: VW Touareg II
Step-by-step adjusting rear glass panel for the VW Touareg II: 5 steps, 3 torque figures. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touareg II (7P, 2010–2018)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 5 Nm (3.7 lb-ft) | Insert and tighten screws on left and right |
| 5 Nm (3.7 lb-ft) | Insert and tighten screws on left and right, specified torque |
| 7 Nm (5.2 lb-ft) | Tighten bolts on left and right (4 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Pull inner seal (5) off assembly frame.
- Loosen bolts (4) for rear glass panel (3).
- Adjust rear glass panel (3) according to dimensions .
- Tighten bolts on left and right (4). Specified torque: 7 Nm — 7 Nm (5.2 lb-ft)
- Position seal (5) on assembly frame.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Repairing TRW power steering
- Assembly overview - brake servo/brake master cylinder to Week 22/2008, LHD
- Assembly overview - brake servo/brake master cylinder from Week 22/2008, LHD
- Repair information for the ABS MK 60 system
- Brake system: vehicles with ABS MK 60 - bleeding
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.