Adjusting brake pedal position sender G100, RHD vehicles: VW Touareg II
Step-by-step adjusting brake pedal position sender G100, RHD vehicles for the VW Touareg II: 14 steps.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touareg II (7P, 2010–2018)
📋 Procedure
- Remove footwell cover General body repairs, interior68Compartments, covers and trims.
- Remove convenience system central control unit -J393- with retainer Electrical system97Control units.
- Loosen bolt (4) until retainer (3) with brake pedal position sender G100(2) can be moved back and forth in (direction of arrow).
- Set dimension (A) so that min. 4 mm to max. 5mm is between brake pedal position sender G100(2) and magnet (1).
- Tighten bolt (4) again.
- Loosen bolt (1) of magnet retainer (2) until magnet retainer (3) can be pushed as far as possible in (direction arrow A) against brake pedal (3).
- Unclip stop tab (1) in (direction of arrow A) from retainer (2) (upper section of illustration).
- Then, fit stop tab from the side onto retainer and engage it in (direction of arrow B) between stops (C) (lower section of illustration).
- Press magnet retainer (2) lightly in (direction of arrow) against engaged stop tab (1).
- Tighten bolt (3) of magnet retainer.
- Unclip stop tab (1) in (direction of arrow A) from retainer (2).
- Then, fit stop tab (1) on retainer (2) and engage it in original position in (direction of arrow B).
- Install convenience system central control unit -J393- with retainer Electrical system97Control units.
- Install footwell cover General body repairs, interior68Compartments, covers and trims.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing high-pressure pump, engine codes BLG and BMY · 2 torque figures
- Gearbox: removal and installation
- VW drive without tensioning roller auxiliary belt replacement · 3 torque figures
- Checking oil level in Haldex coupling – VW · 3 torque figures
- VW CYTA timing belt replacement · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.