5-speed gearbox 085 DS Lupo 3 L, Lupo FSI — Repairing clutch housing — VW

🧭 Before you start

Fits: platform code 6E1

📋 Procedure

1. Pull out selector shaft.
2. In order not do damage selector shaft, wrap it with thin insulation tape.
3. Push in selector lever to stop.
4. Carefully make a hole in middle of seal with a small screwdriver (arrow).
5. Then lever out seal with a slightly larger screwdriver.

6. Remove insulation tape and check selector shaft for damage.
7. Lightly oil outer circumference of oil seal.
8. Fill space between sealing lip and dust lip with sealing greaseG 052 128 A1.
9. Carefully push seal over chamfer of selector shaft with a twisting motion.
10. Use the appropriate end of tool for differing seals.
11. Lightly oil outer circumference of oil seal.
12. Fill space between sealing lip and dust lip with sealing greaseG 052 128 A1.
13. Lightly oil outer circumference of oil seal.
14. Fill space between sealing lip and dust lip with sealing greaseG 052 128 A1.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Retrofitting fuel cut-off valve control unit J366
• Removing, installing and tensioning injection pump toothed belt (engine codes ACV, AHY, AJT, AUF, AXG, AXL, AYC, AYY)
• Checking on wiring loom plug – VW 2.0 AAC
• Removing and installing exhaust turbocharger
• Allocation gearbox - engine/filling capacities