4-speed automatic gearbox 01N — Renewing speedometer sender G22 or driving speed sender G68 — VW
4-speed automatic gearbox 01N — Renewing speedometer sender G22 or driving speed sender G68 on VW: 10 steps.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B5 (3B)
📋 Procedure
- Remove left wheel.
- Remove left drive shaft noise insulation from wheel housing (arrows).
- Pull connector (arrow A) off sender.
- Press down retaining clip on sender and rotate (arrow).
- Pull out sender.
- Replace O-rings (arrows).
- Insert new O-rings with gear oil.
- Insert sender.
- Engage retaining clip on bearing bracket for flange shaft.
- Install left wheel Running gear, axles, steering - front and four-wheel drive44Installing wheels and tyres: Installing wheel.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Allocation gearbox - engine, gear ratio and capacities, four-wheel drive
- Removing and installing connecting pipes – VW 2.0 TDI CFCA
- Removing and installing exhaust gas recirculation cooler, “single turbo engine”
- Removing and installing curtain airbag with igniter, passenger compartment
- Removing and installing floor covering, Transporter
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.