Geometry, turbo — SUBARU
Geometry, turbo on Subaru: 12 steps. What to remove, in what order, and what to check after.
Workshop procedure for SUBARU — the exact step sequence and torque figures, straight from real workshop data.
📋 Procedure
- Measure the ride height from the wheel hub centre to the wheel arch
- Saloon:
- Front ride height (mm):
- Rear ride height (mm):
- Wagon
- Front ride height (mm):
- Rear ride height (mm):
- Camber adjustment
- Toe adjustment
- Rear
Other SUBARU procedures
- Subaru Justy M13, M15 M13A/M15A timing chain replacement
- Subaru 2.0 timing belt replacement
- Subaru Forester 2.5 Turbo DOHC EJ255 timing belt replacement
- Subaru Legacy 2.5_SOHC_Non-turbo EJ25 timing belt replacement
- Subaru 2.5 EJ25/EJ251 timing belt replacement
- 2.0 non-turbo SOHC Impreza my01, Forester my03, Legacy my04
- Subaru Impreza Turbo 2.0 EJ205 cylinder head removal & torque
- Subaru Impreza non turbo gearbox removal & installation
- Subaru Legacy 2.0 EJ20 timing belt replacement
- Legacy EJ20/25 CVT
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.