Cabstar F24 YD25K3LD-5LO — NISSAN
Cabstar F24 YD25K3LD-5LO on Nissan: 13 steps, engines YD25DDTI, YD25K3LD-5, ZD30. What to remove, in what order, and what to check after.
Workshop procedure for NISSAN — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 28.12, |, 34.11, 34.13, 35.15
📋 Procedure
- Severe conditions apply when the vehicle is operated under one or more of the following conditions:
- Driving in dusty conditions
- Driving short distances repeatedly
- Frequent trailer towing
- Prolonged idling
- Driving in extremely hot conditions
- Driving in extremely cold conditions
- Driving in mountainous or high humidity regions
- Driving in wet conditions and/or on salted roads
- Driving on rough and/or muddy roads
- Off-road or desert driving
- Driving with frequent braking
Other NISSAN procedures
- Pick Up D22 YD25DDTi
- Cabstar 28.12 YD25K3LD-5LO
- Nissan Micra K12 CR timing chain replacement
- Nissan non type specific 2.0 dCi timing chain replacement
- Nissan X-Trail T30 QR20, 25 QR20DE timing chain replacement
- Nissan X-Trail T31 2.4 QR25DE timing chain replacement
- Nissan Kubistar 1.5 dCi auxiliary belt replacement
- Nissan Note 1.6 HR16DE timing chain replacement
- Nissan Qashqai 1.6 HR16DE timing chain replacement
- Nissan X-Trail T31 2.0 MR20DE timing chain replacement
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.