Auxiliary belt replacement: Mazda drive (Z6)
Step-by-step auxiliary belt replacement for the Mazda drive (Z6): 14 steps. What to remove, in what order, and what to check after.
Workshop procedure for MAZDA — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 1.6, 16V
🔧 Engine codes this applies to
📋 Procedure
- Turn the tensioner clockwise
- Refit the ancillary drive belt
- Note: Remove as one unit
- Check the condition of the tensioner; renew if necessary
- Remove the ancillary drive belt
Other MAZDA procedures
- Remove MPV GY cylinder head – Mazda GY
- Mazda 6, F3 timing chain replacement
- Mazda 6 Turbo 2.0 diesel timing belt replacement
- Mazda 3 2003 L3/LF timing chain replacement
- Mazda RF timing belt replacement
- Mazda 3 BK RF timing belt replacement
- Mazda 2_Demio 2007 ZJ/ZY timing chain replacement
- Mazda 6 2.2 2008 R2 timing chain replacement
- Mazda 6 2007 timing chain replacement
- Mazda Tribute 3.0 V6 DURATECAJ timing chain replacement
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.