Integra 1.8i Type R B18C6 (S80) 11/97 > — HONDA
Integra 1.8i Type R B18C6 (S80) 11/97 > on Honda: 67 steps, engines B18C6. What to remove, in what order, and what to check after.
Workshop procedure for HONDA — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 1.8, TYPE, R
- Opens: gearbox oil
- Timing position: the crankshaft or camshaft is set and locked during this job
- Special tools named: locking pin
Don't miss
- Do not disconnect the hydraulic circuit
🔧 Engine codes this applies to
📋 Procedure
- Disconnect the battery
- Disconnect the reversing light switch
- Disconnect the gearbox earth connection
- Remove the hose clamp from the bracket
- Disconnect the starter motor electrical connections
- Remove the connector from the vehicle speed sensor
- Disconnect the wiring loom and move it aside
- Disconnect the clutch slave cylinder
- Note: Do not disconnect the hydraulic circuit
- Remove the starter motor lower bolt
- Drain the gearbox oil
- Disconnect the oxygen sensor connection
- Disconnect the front exhaust pipe
- Front exhaust pipe:
- Use new nut(s)
- Remove the damper fork
- Remove the intermediate drive shaft
- Remove the drive shaft nuts
- Remove both front drive shafts
- Remove the clip
- Remove the locking pin
- Disconnect the gearbox operating linkage from the gearbox
- Reinforcement brace:
- Remove the reinforcement brace
- Remove the front right engine support
- Support the engine with a jack stand
- Support the gearbox
- Remove the gearbox mount
- Remove the rear gearbox mounting bolts
- Remove the lower gearbox attaching bolts
- Bolts, gearbox to engine:
- Remove the gearbox
- Refill the gearbox
- Refit the drain plug
Other HONDA procedures
- Honda Accord 2.0 K20A6/K20Z2 timing chain replacement
- Honda Accord 2.4 K24A3 timing chain replacement
- Honda Stream 2.0 K20A1 timing chain replacement
- Honda FRV 2.0 K20A9 timing chain replacement
- Honda CRV engines 2002> timing chain replacement
- Insight spark plug type
- Accord H22A7 98>
- Honda Accord 2.2 H22A7 cylinder head removal & torque
- Honda Accord 98> 1.6 D16B6/D16B7 timing belt replacement
- Honda Concerto, SOHC 1989 1994 D14A1 timing belt replacement
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.