Replacing dipped beam bulb: Audi A2
Step-by-step replacing dipped beam bulb for the Audi A2: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A2 (8Z)
📋 Procedure
- Switch off ignition and remove ignition key.
- Turn light switch to "“0”" position.
- Detach the bonnet .
- Release the spring clip (arrow) and detach the cover (1) from the headlight housing.
- Detach electrical connector (3) from dipped beam bulb.
- Disengage wire clip (1) and remove bulb (2) from housing.
- Insert the new bulb in the housing, taking care not to touch the glass bulb with bare hands.
- Secure the bulb with the spring clip.
- Plug the connector back in and close the housing cover.
- Secure the housing cover with the spring clip.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing fuel filter, vehicles without supplementary fuel pump V393
- Removing and installing rear three-point seat belt, Kombi
- Removing and installing luggage compartment side trim, Multivan, rear, side of vehicle with sliding door
- Removing and installing operating mechanism, with mechanical locking system
- Removing undamaged double cab side window
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.