Renewing stub shaft oil seals (with bevel box removed): Audi TT Mk2
Step-by-step renewing stub shaft oil seals (with bevel box removed) for the Audi TT Mk2: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi TT Mk2 (8J, 2006–2014)
📋 Procedure
- Remove circlip (arrow A) and O-ring (arrow B) from stub shaft.
- Drive stub shaft carefully out of bevel box.
- Pull out stub shaft oil seal on gearbox side.
- Half-fill space between sealing lip and dust lip of new oil seals (arrow) with sealing greaseG 052 128 A1.
- Lightly oil outer circumference of new oil seals.
- Drive in oil seal on gearbox side as far as stop.
- Drive in oil seal on drive shaft side as far as stop.
- Carefully drive stub shaft into bevel box using plastic hammer.
- Install bevel box .
- Check oil level in bevel box .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Checking activation of exhaust gas recirculation valve N18
- Checking activation of secondary air pump relay – Audi A4 B5
- Removing and installing gearbox support (left and right)
- Removing and installing rear window wiper motor – Audi A3
- Removing and installing control unit for gas discharge lamp
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.