Renewing load area protective mouldings — AUDI

🧭 Before you start

Fits: platform code 9U7

📋 Procedure

1. Cut along complete middle of moulding and pull off (moulding is bonded in position)
2. Clean inner profile of moulding with cleaning solution D 009 401 04
3. Cut back adhesive sealing material on body to 1 mm.
4. Clean contact surfaces for moulding on body with cleaning solution D 009 401 04
5. Apply primer D 009 200 02 to both sides of flange (arrows B) (applies only to flanges with no PUR layer)

6. Apply primer D 009 600 to inner side of moulding groove (arrow A)
7. Once primer has "flashed-off", fill protective moulding with 1K window adhesive DH 009 100 03 (preparation )
8. Fit moulding and adapt to fit
9. Unscrew cross-head screws and remove trim
10. Remove hexagon nuts and remove protective moulding
11. Remove trim
12. Remove hexagon nuts
13. Remove cross-head screws .
14. Remove number plate lighting (Qty. 2)

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing bonded rubber bushes for axle beam – Audi A1
• Removing and installing brake caliper · 2 torque figures
• Removing and installing rear expansion valve – Audi Q7 · 2 torque figures
• Removing gearbox - vehicles with 1.4 ltr. TFSI and 2.0 ltr. TFSI engine
• Removing and installing fuel pressure sender G247 / G624 · 2 torque figures