Renewing large seal of stub shaft between manual gearbox and bevel box on bevel box, vehicles up to model year 2010 — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

• Opens: gearbox oil

Don't miss

• When inserting stub shaft, be sure to guide it in straight to avoid damage to seal for sealing bevel box stub shaft to gearbox.

📋 Procedure

1. Remove bevel box .
2. Drain gear oil from bevel box.
3. Secure bevel box to gearbox supportVW 353.
4. Pull shrink tube or thin insulation tube over inner splines of stub shaft (facing gearbox).
5. Withdraw right stub shaft from bevel box.

6. Turn bevel box in assembly bracket with bolting surface for gearbox upwards.
7. Lever out seal with lever T20143/2.
8. Lightly oil new oil seal on outer diameter. Fill space between sealing lips (arrow) half full with sealing greaseElectronic Parts Catalogue.
9. Drive in new seal to stop with thrust piece T10143, being careful not to cant seal.
10. Turn bevel box in assembly bracket with bolting surface for right drive shaft upwards.
11. Insert right stub shaft. [Note: When inserting stub shaft, be sure to guide it in straight to avoid damage to seal for sealing bevel box stub shaft to gearbox.]
12. Remove shrink tube or insulation tube.
13. Install bevel box .
14. Check gear oil in gearbox .
15. Check gear oil in bevel box .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing bracket for on-board supply control unit
• Checking heating output (and activation of temperature flaps) - vehicles with manually controlled air conditioner
• Removing and installing actuator for front air distribution flap (automatically controlled air conditioner)
• Removing and installing retainers for heater and air conditioning unit
• Removing and installing splash plate