Renewing bracket of refrigerant lines — AUDI
Renewing bracket of refrigerant lines on Audi: 4 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Caddy III (2K, 2004–2015); platform code 2C0
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 20 Nm (15 lb-ft) | Unscrew nuts (4 |
| 6 Nm (4.4 lb-ft) | Unscrew nuts (11 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Open clip (5) and unclip refrigerant lines.
- Unscrew nuts (4) (20 Nm) and remove bracket (6). — 20 Nm (15 lb-ft)
- Remove bolt (7).
- Unscrew nuts (11) (6 Nm) and remove bracket. — 6 Nm (4.4 lb-ft)
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing handbrake cable (rear) – Audi TT Mk2
- Removing and installing floor covering, Coupé – Audi TT Mk2
- Removing and installing alternator - Audi TT and TTS with 2.0 ltr. TFSI engine
- Installing bevel box - vehicles with 2.0 ltr. TFSI engine · 1 torque figures
- Installing bevel box - vehicles with 3.2 ltr. MPI engine · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.