Renewing bleeder — AUDI

🧭 Before you start

Fits: platform codes SF, SG

📋 Procedure

1. Release connector (1) and pull off.
2. Pull out wiring harness (3) from expansion tank (2).
3. Unscrew bolts (4) from coolant expansion tank (2) and push coolant expansion tank aside.
4. Pull off cap (arrow) using front-end hook3370.
5. Pull out breather pipe (2) using commercially available pliers (1).

6. Push on breather pipe (2) powerfully by hand.
7. Remove breather pipe (3).
8. Unclip line (3) with retainer (2). Then loosen connection on gearbox (4).
9. Secure connection on gearbox (4).
10. Press bleeder pipe (3) on by hand by pushing it firmly onto gearbox and clip it on again by means of the retainer (2).
11. You should feel and hear the pipe engaging.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Installing sump (top section) - "engine generation II" – Audi · 1 torque figures
• Multi-function steering wheel with thumbwheels · 1 torque figures
• Removing and installing bracket for ancillaries - vehicles with small engine support
• Removing and installing temperature sender before particulate filter G506
• Removing and installing cup holder/storage compartment in centre console (top section)