Renewing bevel box output flange oil seal — AUDI

🧭 Before you start

Fits: VW Transporter T6 (7E)

• Special tools named: puller

Don't miss

• When pulling off output flange of bevel box with universal pullerKukko 18-1 , ensure that flange is not canted to prevent damaging dust cover (arrow).

📋 Procedure

1. Remove front propshaft. Propshaft and rear final drive39Final drive, rear differential
2. Remove circlip ring with appropriate circlip pliers.
3. Pull off output flange of bevel box with universal puller KUKKO 18-1. [Note: When pulling off output flange of bevel box with universal pullerKukko 18-1 , ensure that flange is not canted to prevent damaging dust cover (arrow).]
4. Lever out seal using puller hooks T20143/2 .
5. Lightly oil new oil seal on outer diameter. Fill space between sealing lips (arrow) half full with sealing greaseG 052 128 A1 .

6. Drive in oil seal without canting it, using thrust piece T10143.
7. Install output flange / bevel box together with dust disc.
8. Fit circlip.
9. Install front propshaft tube Propshaft and rear final drive39Final drive, rear differential.
10. Check / top up gear oil in bevel box .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing charger pressure positioner V465 - all engine codes except CJZA, CSSA, CYVB
• Removing and installing fuel pump control unit J538 - vehicles without high-voltage system
• Removing and installing anti-roll bar (multi-link suspension - four-wheel drive vehicles)
• Removing and installing earth cable with battery monitor control unit J367 - battery in engine compartment
• Removing and installing earth cable with battery monitor control unit J367 - battery in luggage compartment