Removing undamaged wing door window — AUDI

🧭 Before you start

Fits: platform codes SF, SG

📋 Procedure

1. Remove wiper arm Electrical system92Rear window wiper system; Removing and installing wiper arm.
2. Pull off connection for heated rear window and press connecting tab onto window.
3. Use awlV.A.G 1474/2(2) to poke through adhesive sealant outwards.
4. Pull cutting cord (1) through adhesive sealant into vehicle interior using awlV.A.G 1474/2.
5. On inside, prevent end of cutting cord (2) from being pulled out by attaching it to pull handleV.A.G 1351/1(1).

6. Guide cutting cord (2) around wing door window.
7. Guide other end of cord into vehicle as well.
8. Secure other end of cutting cord to reel deviceV.A.G 1654 A.
9. Cut wing door window free by moving reel deviceV.A.G 1654 A to required position.
10. Use wedgeV.A.G 1474/5 to press cutting cord against wing door window while cutting in order to have clearance at window flange.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• 6-cylinder TDI engine (3.0 ltr. 4-valve common rail, SCR), mechanics — Securing engine to engine and gearbox support · 1 torque figures
• Removing and installing refrigerant lines at air conditioning unit
• Removing and installing drive shaft with 100 mm ∅ outer constant velocity joint and 108 mm ∅ inner constant velocity joint · 1 torque figures
• Removing and installing engine compartment cross member - R8 Coupé with dual-clutch gearbox 0BZ
• Removing and installing seat occupied recognition system - country-specific version