Removing latch trim: Audi TT Mk1
Step-by-step removing latch trim for the Audi TT Mk1: 7 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi TT Mk1 (8N)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 10 Nm (7.4 lb-ft) | Tightening torque |
| 2 Nm (1.5 lb-ft) | Tightening torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove left or right rear seat backrest .
- Do not unscrew bolt (2).
- Unscrew bolts (3) (2x).
- Tightening torque 10 Nm — 10 Nm (7.4 lb-ft)
- Unscrew bolt (4).
- Tightening torque 2 Nm — 2 Nm (1.5 lb-ft)
- Detach latch trim (1).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing selector mechanism on vehicles with vehicle ID No. from 8E_8A 002700 onwards
- Removing and installing selector mechanism up to 09.98 – Audi
- Adjusting selector mechanism from 09.98 – Audi A3
- Automatic gearbox 01V, self-diagnosis — Final control diagnosis - gearbox with hydraulic control "“Type E18/2”"
- Filling up gear oil in gearbox after repairs (gearbox with common oil system)
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.