Removing Haldex coupling - final drive remains installed — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

Don't miss

• The flexible pipe connection (de-coupling element) of exhaust system must not be bent more than 10 ° - otherwise it can be damaged.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Separate exhaust system at clamp (arrows) and remove rear section of exhaust system (repair group 26). [Note: The flexible pipe connection (de-coupling element) of exhaust system must not be bent more than 10 ° - otherwise it can be damaged.]
2. Remove flexible coupling (rear) (see the separate procedure).
3. Unplug connector (2) on four-wheel drive control unit J492.
4. Position drip tray VAS 6208 under final drive.
5. Remove drain plug (A) and drain high performance oil for Haldex coupling completely.
6. Fit drain plug (A) with new seal and tighten to 30 Nm. — 30 Nm (22 lb-ft)
7. Unscrew securing bolts (arrows) and remove Haldex coupling from rear final drive.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing Y-pipe – Audi A8 D4 CDSB/CTEC
• Renewing adapter cable with tubular cable terminal – Audi CDSB
• Removing and installing starter - vehicles with 4.2 ltr. TDI engine
• Removing and installing output module 3 for LED headlight A29/A33 - vehicles from model year 2014 onwards
• Removing and installing headlight fan V407/V408 - vehicles from model year 2014 onwards