Removing and installing starter - vehicles with 4.2 ltr. TDI engine — AUDI

🧭 Before you start

Fits: Audi A8 D4 (4H, 2010–2017)

Don't miss

• Check whether locking part (1) is properly inserted in starter opening before installing starter.

📋 Procedure

1. Disconnect earth cable from battery with ignition switched off .
2. Lower subframe Running gear, axles, steering40Subframe; Exploded view - subframe.
3. Remove bolts (arrows).
4. Detach engine support (1) with bracket for turbocharger.
5. Unplug connector (4) by sliding locking element to rear and pressing down release catch.

6. Unscrew nut (3) and detach B+ wire from solenoid switch.
7. Remove bolt (5).
8. Remove bolt (1) from above.
9. Detach starter (2).
10. Check whether locking part (1) is properly inserted in starter opening before installing starter.
11. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking terminal 30 voltage supply relay (diesel direct injection system control unit 2J494)
• Removing air cleaner housing (right-side) - vehicles with 10-cyl. petrol engine
• Removing and installing entry and start authorisation button E408 or driver identification control unit J589
• Removing and installing relay and fuse carrier behind dash panel (left-side)
• Removing and installing navigation system operating unit in centre console